With eccentric clamping · For the rapid change of machining tools with a constant repeat accuracy of 0.01 mm · The height of tip is adjusted by an adjusting screw on the turning tool holder · The serration and the bearing surface are hardened and ground · 40 teeth in the steel holder head allow 40 different angular settings of the tools (9° each) Bore Ø = bore in the central body Max. radius = centre of the bore to the end/edge of the quick-change holder Further technical information: · Max. radius: 30mm

With eccentric clamping · For the rapid change of machining tools with a constant repeat accuracy of 0.01 mm · The height of tip is adjusted by an adjusting screw on the turning tool holder · The serration and the bearing surface are hardened and ground · 40 teeth in the steel holder head allow 40 different angular settings of the tools (9° each) Bore Ø = bore in the central body Max. radius = centre of the bore to the end/edge of the quick-change holder Further technical information: · Max. radius: 48mm

With eccentric clamping · For the rapid change of machining tools with a constant repeat accuracy of 0.01 mm · The height of tip is adjusted by an adjusting screw on the turning tool holder · The serration and the bearing surface are hardened and ground · 40 teeth in the steel holder head allow 40 different angular settings of the tools (9° each) Bore Ø = bore in the central body Max. radius = centre of the bore to the end/edge of the quick-change holder Further technical information: · Max. radius: 71mm

With eccentric clamping · For the rapid change of machining tools with a constant repeat accuracy of 0.01 mm · The height of tip is adjusted by an adjusting screw on the turning tool holder · The serration and the bearing surface are hardened and ground · 40 teeth in the steel holder head allow 40 different angular settings of the tools (9° each) Bore Ø = bore in the central body Max. radius = centre of the bore to the end/edge of the quick-change holder Further technical information: · Max. radius: 92/102mm

With eccentric clamping · For the rapid change of machining tools with a constant repeat accuracy of 0.01 mm · The height of tip is adjusted by an adjusting screw on the turning tool holder · The serration and the bearing surface are hardened and ground · 40 teeth in the steel holder head allow 40 different angular settings of the tools (9° each) Bore Ø = bore in the central body Max. radius = centre of the bore to the end/edge of the quick-change holder Further technical information: · Max. radius: 112/116/124mm